Title page for ETD etd-02232009-054512


Type of Document Master's Thesis
Author Hunt, Michael Patrick
URN etd-02232009-054512
Title Pressureless Densification of Alumina - Titanium Diboride Ceramic Matrix Composites
Degree Master of Science
Department Materials Science and Engineering
Advisory Committee
Advisor Name Title
Logan, Kathryn V. Committee Chair
Clark, David E. Committee Member
Pickrell, Gary R. Committee Member
Suchicital, Carlos T. A. Committee Member
Keywords
  • Aluminum Oxide
  • Titanium Diboride
  • Rate Controlling Diffusion Mechanism
  • SHS Produced Composites
  • Densification
  • Aluminum Borate
Date of Defense 2009-02-04
Availability unrestricted
Abstract
The research focus was to determine diffusion mechanisms responsible for densification behavior of SHS produced Al2O3/TiB2 Ceramic Matrix Composites (CMCs). Previous research has shown SHS produced Al2O3/TiB2 composites exhibited unique microstructural properties that contributed to high strength, fracture toughness, and hardness properties. Pressureless densification of SHS produced Al2O3/TiB2 composites would provide a cost savings because the equipment for pressureless densification is less expensive and less complicated than equipment required for densification with pressure.

Models for sintering of CMCs and calculation of Sintering Time Constants (STC) were used to predict the densification behavior of the SHS produced Al2O3/TiB2 composite. The Levin, Dirnfeld, Shwam equation was used to determine the Rate Controlling Diffusion Mechanism (RCDM) and activation energy for sintering. X-Ray Diffraction (XRD) analysis of the as-milled reaction product powder revealed the presence of an aluminum borate (Al18B4O33) as a third phase, as well as, in pressureless heat treated samples. Based on experimental results and analysis, it seemed possible the Al18B4O33 compound may have formed by reaction of Al2O3 with TiB2 along their interfaces. Aluminum borates have been observed to form Al18B4O33 (s) + B2O3 (l) at temperatures above 1000°C. The RCDM for densification of SHS produced Al2O3/TiB2 was found to be liquid phase diffusion with volume diffusion also likely being active during densification. In addition, Al18B4O33 seemed to be the preferred compound formed during oxidation. Further research should be performed to control formation of Al18B4O33; as well as, on the oxidation behavior of the SHS produced Al2O3/TiB2.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Hunt_Thesis_030809.pdf 45.92 Mb 03:32:35 01:49:20 01:35:40 00:47:50 00:04:04

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.