Type of Document Master's Thesis Author Crispino, Eric Daniel Author's Email Address firstname.lastname@example.org URN etd-03122007-144128 Title Anchorage Zone Design for Pretensioned Bulb-Tee Bridge Girders in Virginia Degree Master of Science Department Civil Engineering Advisory Committee
Advisor Name Title Cousins, Thomas E. Committee Co-Chair Roberts-Wollmann, Carin L. Committee Co-Chair Davis, Rodney T. Committee Member Keywords
- Anchorage Zone
- Pretensioned Bridge Girder
- Strut-and-Tie Model
Date of Defense 2007-03-01 Availability unrestricted AbstractPrecast/Prestressed concrete girders are commonly used in bridge construction in the United States. The application and diffusion of the prestress force in a pretensioned girder causes a vertical tension force to develop near the end of the beam. Field surveys of the beam ends of pretensioned bridge girders indicate that many of the PCBT beams used in the Commonwealth of Virginia develop cracks within the anchorage zone region. The lengths and widths of these cracks range from acceptable to poor and in need of repair. Field observations also indicate deeper cross sections, very heavily prestressed sections, and girders with lightweight concrete tend to be most susceptible to crack formation.
This research examined a new strut-and-tie based design approach to the anchorage zone design of the PCBT bridge girders used in Virginia. Case study girders surveyed during site visits are discussed and used to illustrate the nature of the problem and support the calibration of the strut-and-tie based model. A parametric study was conducted using this proposed design model and the results of this study were consolidated into anchorage zone design tables. The results of the parametric study were compared to the results obtained using existing anchorage zone design models, international bridge codes, and standard anchorage zone details used by other states. A set of new standard details was developed for the PCBT girders which incorporates elements of the new design approach and is compatible with the anchorage zone design aids.
A 65 ft PCBT-53 girder was fabricated to verify the new strut-and-tie based design model. This girder contained anchorage zone details designed with the new model. The new anchorage zone details were successful at controlling the development of anchorage zone cracks. The new design approach is recommended for implementation by the Virginia Department of Transportation.
Filename Size Approximate Download Time (Hours:Minutes:Seconds)
28.8 Modem 56K Modem ISDN (64 Kb) ISDN (128 Kb) Higher-speed Access Eric_Crispino_Thesis.pdf 4.65 Mb 00:21:30 00:11:03 00:09:40 00:04:50 00:00:24
If you have questions or technical problems, please Contact DLA.