Title page for ETD etd-04042012-103018


Type of Document Dissertation
Author Sun, Pengwei
URN etd-04042012-103018
Title Cascade Dual-Buck Inverters for Renewable Energy and Distributed Generation
Degree PhD
Department Electrical and Computer Engineering
Advisory Committee
Advisor Name Title
Lai, Jih-Sheng Jason Committee Chair
Centeno, Virgilio A. Committee Member
Meehan, Kathleen Committee Member
Nelson, Douglas J. Committee Member
Yu, Wensong Committee Member
Keywords
  • cascade
  • dual-buck
  • inverter
  • phase-shift
  • PWM
  • grid-tie
Date of Defense 2012-03-28
Availability unrestricted
Abstract
Renewable energy and distributed generation are getting more and more popular, including photovoltaic modules (PV), wind turbines, and fuel cells. The renewable energy sources need the power electronics interface to the utility grid because of different characteristics between the sources and the grid. No matter what renewable energy source is utilized, inverters are essential in the microgrid system. Thanks to flexible modular design, transformerless connection, extended voltage and power output, less maintenance and higher fault tolerance, the cascade inverters are good candidates for utility interface of various renewable energy sources.

This dissertation proposes a new type of cascade inverters based on dual-buck topology and phase-shift control scheme. Compared to traditional cascade inverters, they have enhanced system reliability thanks to no shoot-through problems and lower switching loss with the help of using power MOSFETs. With phase-shift control, it theoretically eliminates the inherent current zero-crossing distortion of the single-unit dual-buck type inverter. In addition, phase-shift control can greatly reduce the ripple current or cut down the size of passive components by increasing the equivalent switching frequency.

An asymmetrical half-cycle unipolar (AHCU) PWM technique is proposed for dual-buck full-bridge inverter. The proposed approach is to cut down the switching loss of power MOSFETs by half. At the same time, this AHCU PWM leads to current ripple reduction, and thus reducing ripple-related loss in filter components. Therefore, the proposed PWM strategy results in significant efficiency improvement. Additionally, the AHCU PWM also compensates for the zero-crossing distortion problem of dual-buck full-bridge inverter. Several PWM techniques are analyzed and compared, including bipolar PWM, unipolar PWM and phase-shifted PWM, when applied to the proposed cascade dual-buck full-bridge inverter. It has been found out that a PWM combination technique with the use of two out of the three PWMs leads to better performance in terms of less output current ripple and harmonics, no zero-crossing distortion, and higher efficiency.

A grid-tie control system is proposed for cascade dual-buck inverter with both active and reactive power flow capability in a wide range under two types of renewable energy and distributed generation sources. Fuel cell power conditioning system (PCS) is Type I system with active power command generated by balance of plant (BOP) of each unit; and photovoltaic or wind PCS is Type II system with active power harvested by each front-end unit through maximum power point tracking (MPPT). Reactive power command is generated by distributed generation (DG) control site for both systems. Selective harmonic proportional resonant (PR) controller and admittance compensation controller are first introduced to cascade inverter grid-tie control to achieve better steady-state and dynamic performances.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Sun_P_D_2012.pdf 8.24 Mb 00:38:09 00:19:37 00:17:10 00:08:35 00:00:43

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.