Title page for ETD etd-05082008-144350


Type of Document Dissertation
Author Smith, Benjamin Scott
Author's Email Address besmith5@vt.edu
URN etd-05082008-144350
Title Wall Jet Boundary Layer Flows Over Smooth and Rough Surfaces
Degree PhD
Department Aerospace and Ocean Engineering
Advisory Committee
Advisor Name Title
Devenport, William J. Committee Chair
Burdisso, Ricardo A. Committee Co-Chair
Neu, Wayne L. Committee Member
Ng, Fai Committee Member
Simpson, Roger L. Committee Member
Keywords
  • wall jet
  • rough surface
  • turbulent boundary layer
  • surface pressure fluctuations
Date of Defense 2008-04-21
Availability unrestricted
Abstract
The aerodynamic flow and fluctuating surface pressure of a plane, turbulent, two-dimensional wall jet flow into still air over smooth and rough surfaces has been investigated in a recently constructed wall jet wind tunnel testing facility. The facility has been shown to produce a wall jet flow with Reynolds numbers based on the momentum thickness, Re&delta = &deltaUm/&nu, of between 395 and 1100 and nozzle exit Reynolds numbers, Rej = Umb/&nu, of between 16000 and 45000. The wall jet flow properties (&delta, &delta*, &theta, y1/2, Um, u*, etc.) were measured and characterized over a wide range of initial flow conditions and measurement locations relative to the wall jet source. These flow properties were measured for flow over a smooth flow surface and for flow over roughness patches of finite extent. The patches used in the current study varied in length from 305 mm to 914 mm (between 24 and 72 times the nozzle height, b) and were placed so that the leading edge of the patch was fixed at 1257 mm (x/b = 99) downstream of the wall jet source. These roughness patches were of a random sand grain roughness type and the roughness grain size was varied throughout this experiment. The tests covered roughness Reynolds numbers (k+) ranging from less than 2 to over 158 (covering the entire range of rough wall flow regimes from hydrodynamically smooth to fully rough). For the wall jet flows over 305 mm long patches of roughness, the displacement and momentum thicknesses were found to vary noticeably with the roughness grain size, but the maximum velocity, mixing layer length scale, y1/2, and the boundary layer thickness were not seen to vary in a consistent, determinable way. Velocity spectra taken at a range of initial flow conditions and at several distinct heights above the flow surface showed a limited scaling dependency on the skin friction velocity near the flow surface.

The spectral density of the surface pressure of the wall jet flow, which is not believed to have been previously investigated for smooth or rough surfaces, showed distinct differences with that seen in a conventional boundary layer flow, especially at low frequencies. This difference is believed to be due to the presence of a mixing layer in the wall jet flow. Both the spectral shape and level were heavily affected by the variation in roughness grain size. This effect was most notable in overlap region of the spectrum. Attempts to scale the wall jet surface pressure spectra using outer and inner variables were successful for the smooth wall flows. The scaling of the rough wall jet flow surface pressure proved to be much more difficult, and conventional scaling techniques used for ordinary turbulent boundary layer surface pressure spectra were not able to account for the changes in roughness present during the current study. An empirical scaling scheme was proposed, but was only marginally effective at scaling the rough wall surface pressure.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  BS_Dissertation_Submitted_Final.pdf 6.06 Mb 00:28:02 00:14:25 00:12:36 00:06:18 00:00:32

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.