Title page for ETD etd-05112011-143759


Type of Document Master's Thesis
Author Lippy, Matthew Stephen
Author's Email Address mlippy38@vt.edu
URN etd-05112011-143759
Title Development of a Minichannel Compact Primary Heat Exchanger for a Molten Salt Reactor
Degree Master of Science
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Pierson, Mark A. Committee Chair
Ekkad, Srinath V. Committee Member
Hendricks, Robert W. Committee Member
Keywords
  • nuclear
  • molten salt reactor
  • primary heat exchanger
  • compact heat exchanger
  • heat exchanger
Date of Defense 2011-04-28
Availability unrestricted
Abstract
The first Molten Salt Reactor (MSR) was designed and tested at Oak Ridge National Laboratory (ORNL) in the 1960’s, but recent technological advancements now allow for new components, such as heat exchangers, to be created for the next generation of MSR’s and molten salt-cooled reactors. The primary (fuel salt-to-secondary salt) heat exchanger (PHX) design is shown here to make dramatic improvements over traditional shell-and-tube heat exchangers when changed to a compact heat exchanger design. While this paper focuses on the application of compact heat exchangers on a Molten Salt Reactor, many of the analyses and results are similarly applicable to other fluid-to-fluid heat xchangers.

The heat exchanger design in this study seeks to find a middle-ground between shell- and-tube designs and new ultra-efficient, ultra-compact designs. Complex channel geometries and microscale dimensions in modern compact heat exchangers do not allow routine maintenance to be performed by standard procedures, so extended surfaces will be omitted and hydraulic diameters will be kept in the minichannel regime (minimum channel dimension between 200 μm and 3 mm) to allow for high-frequency eddy current inspection methods to be developed. High aspect ratio rectangular channel cross-sections are used. Various plant layouts of smaller heat exchanger banks in a “modular” design are introduced.

FLUENT was used within ANSYS Workbench to find optimized heat transfer and hydrodynamic performance. With similar boundary conditions to ORNL’s Molten Salt Breeder Reactor’s shell-and-tube design, the compact heat exchanger interest in this thesis will lessen volume requirements, lower fuel salt volume, and decrease material usage.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Lippy_MS_T_2011.pdf 3.71 Mb 00:17:10 00:08:49 00:07:43 00:03:51 00:00:19

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.