This dissertation describes the impact of defects on monolayer properties for self-assembled monolayers (SAMs) created by interfacial patterning methods. When forming a two-dimensional interfacial pattern with n-alkanethiols on gold, the desired electrochemical properties are those of a homogeneous, solution adsorbed monolayer. However, even well-ordered SAMs contain a small degree of defects, especially at domain boundaries where two nucleating domains converge. Patterning a surface creates user-defined domain boundaries within the monolayer, potentially having a significant impact on the properties of the interface. This dissertation investigates the effect that user-created domain boundaries have on the properties of a monolayer, as studied by electrochemical impedance spectroscopy.
Two patterning methods are investigated for creating user-defined domain boundaries: the soft lithography method of contact printing and site-selective reductive desorption. The electrochemical properties of homogeneous contact printed monolayers are measured and compared to those of monolayers prepared by solution adsorption. The contact printed monolayers are found to have dramatically different impedance behavior from the solution prepared monolayers, consistent with the contact printed monolayers having greater defect density. In addition, these studies show that the overall defect density depends on the concentration of the solutions used for contact printing.
In this work, simple patterns are created by contact printing a pattern onto the substrate and then backfilling the remaining gold substrate by solution adsorption. Backfilling with the same alkanethiol used to create the pattern generates a homogeneous monolayer; however, it is found that the contact printed/backfilled monolayer has an impedance intermediate between the homogeneous contact printed and the homogeneous solution adsorbed monolayer. This result suggests that the backfilling process also saturates the pinhole defects associated with the contact printed areas. In addition to exploring defects that arise from contact printing, simple patterns with user-defined defects, created by site-selective reductive desorption (SSRD), were also investigated. Following the backfill step, the impedance behavior of the SSRD produced patterns was similar to that of the impedance of the initial pattern before backfilling. This important result implies that the domain boundaries play the most important role in defining the overall impedance of the patterned interface.
indicates that a file or directory is accessible from the Virginia Tech campus network only.
