Title page for ETD etd-08282008-225723


Type of Document Dissertation
Author Lehne, Mark
Author's Email Address lehne@vt.edu
URN etd-08282008-225723
Title An Analog/Mixed Signal FFT Processor for Ultra-Wideband OFDM Wireless Transceivers
Degree PhD
Department Electrical and Computer Engineering
Advisory Committee
Advisor Name Title
Raman, Sanjay Committee Chair
Ellingson, Steven W. Committee Member
Patterson, Cameron D. Committee Member
Reed, Jeffrey Hugh Committee Member
Tront, Joseph G. Committee Member
Woodall, William H. Committee Member
Keywords
  • OFDM
  • UWB
  • MB-OFDM
  • FFT Processor
  • Analog
  • IC
  • CMOS
  • Mixed Signal
Date of Defense 2008-07-28
Availability unrestricted
Abstract
As Orthogonal Frequency Division Multiplexing (OFDM) becomes more prevalent in

new leading-edge data rate systems processing spectral bandwidths beyond 1 GHz, the

required operating speed of the baseband signal processing, specifically the Analog-

to-Digital Converter (ADC) and Fast Fourier Transform (FFT) processor, presents

significant circuit design challenges and consumes considerable power. Additionally,

since Ultra-WideBand (UWB) systems operate in an increasingly crowded wireless

environment at low power levels, the ability to tolerate large blocking signals is critical.

The goals of this work are to reduce the disproportionately high power consumption

found in UWB OFDM receivers while increasing the receiver linearity to better handle

blockers.

To achieve these goals, an alternate receiver architecture utilizing a new FFT processor is proposed. The new architecture reduces the volume of information passed

through the ADC by moving the FFT processor from the digital signal processing

(DSP) domain to the discrete time signal processing domain. Doing so offers a reduction in the required ADC bit resolution and increases the overall dynamic range of the UWB OFDM receiver.

To explore design trade-offs for the new discrete time (DT) FFT processor, system

simulations based on behavioral models of the key functions required for the processor

are presented. A new behavioral model of the linear transconductor is introduced

to better capture non-idealities and mismatches. The non-idealities of the linear

transconductor, the largest contributor of distortion in the processor, are individually

varied to determine their sensitivity upon the overall dynamic range of the DT FFT

processor. Using these behavioral models, the proposed architecture is validated and

guidelines for the circuit design of individual signal processing functions are presented.

These results indicate that the DT FFT does not require a high degree of linearity

from the linear transconductors or other signal processing functions used in its design.

Based on the results of the system simulations, a prototype 8-point DT FFT processor is designed in 130 nm CMOS. The circuit design and layout of each of the circuit

functions; serial-to-parallel converter, FFT signal flow graph, and clock generation

circuitry is presented. Subsequently, measured results from the first proof-of-concept

IC are presented. The measured results show that the architecture performs the

FFT required for OFDM demodulation with increased linearity, dynamic range and

blocker handling capability while simultaneously reducing overall receiver power consumption. The results demonstrate a dynamic range of 49 dB versus 36 dB for the

equivalent all-digital signal processing approach. This improvement in dynamic range

increases receiver performance by allowing detection of weak sub-channels attenuated

by multipath. The measurements also demonstrate that the processor rejects large

narrow-band blockers, while maintaining greater than 40 dB of dynamic range. The

processor enables a 10x reduction in power consumption compared to the equivalent

all digital processor, as it consumes only 25 mWatts and reduces the required ADC bit

depth by four bits, enabling application in hand-held devices.

Following the success of the first proof-of-concept IC, a second prototype is designed to

incorporate additional functionality and further demonstrate the concept. The second

proof-of-concept contains an improved version of the serial-to-parallel converter and

clock generation circuitry with the additional function of an equalizer and parallel-

to-serial converter.

Based on the success of system level behavioral simulations, and improved power

consumption and dynamic range measurements from the proof-of-concept IC, this

work represents a contribution in the architectural development and circuit design of

UWB OFDM receivers. Furthermore, because this work demonstrates the feasibility

of discrete time signal processing techniques at 1 GSps, it serves as a foundation that

can be used for reducing power consumption and improving performance in a variety

of future RF/mixed-signal systems.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Dissertation_MarkL_100208.pdf 8.90 Mb 00:41:12 00:21:11 00:18:32 00:09:16 00:00:47

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.