Title page for ETD etd-09172008-022306


Type of Document Dissertation
Author Fang, Jian
Author's Email Address jifang@vt.edu
URN etd-09172008-022306
Title Thermoreversible Gelation, Crystallization and Phase Separation Kinetics in Polymer Solutions under High Pressure
Degree PhD
Department Chemical Engineering
Advisory Committee
Advisor Name Title
Kiran, Erdogan R. Committee Chair
Angel, Ross J. Committee Member
Davis, Richey M. Committee Member
Martin, Stephen M. Committee Member
Keywords
  • Crystallization
  • Gelation
  • Phase Separation Kinetic
  • Phase Behavior
Date of Defense 2008-09-10
Availability unrestricted
Abstract
Thermoreversible Gelation, Crystallization and Phase Separation Kinetics in Polymer Solutions under High Pressure

Jian Fang

Abstract

This thesis is an experimental investigation of phase behavior, crystallization, gelation and phase separation kinetics of polymer solutions in dense fluids at high pressures.

The miscibility and dynamics of phase separation were investigated in solutions of atactic polystyrene with low polydispersity (Mw = 129,200; PDI = 1.02) in acetone. Controlled pressure quench experiments were conducted at different polymer concentrations to determine both the binodal and the spinodal envelops using time- and angle resolved light scattering techniques. At each concentration, a series of rapid pressure quenches with different penetration depths in a range from 0.1 MPa to 3 MPa were imposed and the time evolution of the angular distribution of the scattered light intensities was monitored. The solution with 11.4 wt % polymer concentration underwent phase separation by spinodal decomposition mechanism for both shallow and deep quenches. Below this critical polymer concentration, phase separation was found to proceed by nucleation and growth mechanism for shallow quenches, but by spinodal decomposition for deeper quenches.

Gelation and crystallization processes and the influence of pressure and the fluid [Cho et al. 1993]composition were investigated in solutions of poly(4-methyl-1-pentene) [P4MP1] in n-pentane + CO2 and in solutions of syndiotactic polystyrene [sPS] in toluene + CO2, and also in acetophenone + CO2 fluid mixtures over a pressure range up to 55 MPa and carbon dioxide levels up to 50 wt %.

In pure pentane, P4MP1 undergoes crystallization and leads to Form III polymorph at low pressures, but to Form II at high pressures. In n-pentane + CO2 mixture fluids, the polymorphic state changes from a mixture of Forms III and II to Form II and eventually to Form I with increasing CO2 content. High level of carbon dioxide (≥40 wt %) in the solution was found to lead to gelation instead of crystallization. No liquid-liquid phase boundaries could be observed in any of the P4MP1 solutions.

In contrast to P4MP1 in n-pentane, syndiotactic polystyrene was found to undergo gelation in toluene or acetophenone forming a polymer-solvent compound with the δ crystal form. Also in contrast to P4MP1 systems, addition of carbon dioxide to sPS solutions alters the process from that of gelation to crystallization leading to the β crystal form. In solutions with high CO2 level, in addition to the gelation or crystallization boundaries, a liquid-liquid phase separation boundary was also observed.

The phase separation path followed was found to influence the eventual morphology and the crystal state of the polymer. In sPS solutions in toluene + CO2, if the sol-gel boundary were crossed first by cooling the solution at a fixed pressure, the resulting morphology was found to be fibrillar and the polymer displayed the δ crystal form. If instead, the liquid–liquid phase boundary were crossed first by reducing pressure at a fixed temperature, the polymer-rich phase leads to a stacked-lamellar morphology with the β crystal form while the polymer-lean phase leads to a mixed morphology with lamellar layers connected by fibrils with the polymer displaying δ + β crystal forms.

In solutions in acetophenone + carbon dioxide, when the gelation boundary is crossed first, the resulting structure is the δ form as in the toluene + CO2 case. At comparable CO2 levels, when the L-L phase boundary is crossed first, in the acetophenone system, polymer-rich phase was found to generate a mixture of δ + β forms while only the δ form was found in the polymer-lean phase, in contrast to the observations in the toluene + CO2 systems.

Based on crystallographic, spectral and microscopic data, a thermodynamic framework was developed which provides a mechanistic account for the formation of the different polymorphs.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  JianFangDissertationETD.pdf 6.39 Mb 00:29:34 00:15:12 00:13:18 00:06:39 00:00:34

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.