Title page for ETD etd-10312008-131342


Type of Document Dissertation
Author Clark, Matthew Taylor
Author's Email Address clarkmt@vt.edu
URN etd-10312008-131342
Title The driven and stochastic dynamics of micro and nanoscale cantilevers in viscous fluid and near a solid boundary
Degree PhD
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Paul, Mark R. Committee Chair
Huxtable, Scott T. Committee Member
Stremler, Mark A. Committee Member
Tafti, Danesh K. Committee Member
Vick, Brian L. Committee Member
Keywords
  • detection
  • actuation
  • numerical simulation
  • atomic force microscopy
  • fluid dynamics
  • fluctuation-dissipation theorem
Date of Defense 2008-10-24
Availability unrestricted
Abstract
Micro and nanoscale systems are rapidly evolving to improve the resolution of experimental measurements. Experiments involving such small scale devices are difficult and expensive, and the available analytical theory to describe their dynamics is idealized. The dynamics of microscopic cantilevers in fluid are complicated and include significant contributions from many sources in an actual experiment. Some examples are: complex cantilever geometries, near-wall effects, thermal and external actuation techniques, and a variety of measurement techniques. Numerical simulations are a powerful approach to describe the dynamics of micro and nanoscale systems for the precise conditions of experiment. This thesis provides a numerical approach capable of addressing these inherent challenges and quantifies the dynamics of microscopic cantilevers in fluid for experimentally relevant conditions.

A thermodynamic approach based upon the fluctuation-dissipation theorem allows for the calculation of stochastic dynamics from deterministic dynamics. Using numerical simulations, the thermal motion can be described for the precise conditions of experiment. It is found that the measured dynamics of cantilevers differs depending on the quantity being measured. In particular, the dynamics of displacement and angle of the cantilever tip distribute energy differently to the higher flexural modes. The externally driven dynamics of microscale cantilevers in fluid are also considered. The driven dynamics are calculated using numerical simulations of the cantilever response to a force impulse. It is found that the driven dynamics depend upon the type of actuation in addition to the quantity measured. A comparison of the driven dynamics to the corresponding stochastic dynamics yields insight into the nature of the Brownian force acting on the cantilever.

Another experimentally relevant condition is the use of cantilevers with V-shaped planforms in fluid. The resulting flow field is three-dimensional and complex in contrast to what is found for a long and slender rectangular cantilever. Despite the flow complexity, the stochastic and driven dynamics of the fundamental mode can be predicted using a two-dimensional model with an appropriately chosen length scale. An experimentally motivated magnetomotive actuation technique is investigated. Results show that this approach generates power spectra nearly equivalent to the noise spectra. Furthermore, the case of a V-shaped cantilever in fluid and oscillating in proximity of a solid boundary is investigated. In the presence of a solid surface the fluid damping and added mass of fluid on the cantilever are larger than for a cantilever far from boundaries. This results in a lower frequency and quality factor for the fundamental resonance. This can impede experimental efforts because broad peaks lack distinct features that can be used to identify experimental signals.

An option to overcome the large viscous damping is to take advantage of higher modes of cantilever oscillation. The higher frequency oscillations of the higher modes generate a smaller viscous boundary layer and have a reduced added mass. As a result, the quality factor increases with increasing mode number. The frequency dependence of the fluid dynamics around a fluctuating microscale cantilever is also studied. The mass of fluid entrained by the cantilever and the viscous damping quantify the interaction of a cantilever with the surrounding fluid and are computed. Analytical expressions for these parameters are derived for moderate mode number. The techniques and findings of this thesis have broad applicability to a wide range of micro and nanotechnologies that rely upon understanding the dynamics of small scale structures in fluid.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  mtc-thesis.pdf 2.07 Mb 00:09:35 00:04:55 00:04:18 00:02:09 00:00:11

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.