Type of Document Dissertation Author Makhecha, Dhaval Pravin Author's Email Address firstname.lastname@example.org URN etd-11172005-002915 Title Dynamic Fracture of Adhesively Bonded Composite Structures Using Cohesive Zone Models Degree PhD Department Aerospace and Ocean Engineering Advisory Committee
Advisor Name Title Kapania, Rakesh K. Committee Chair Batra, Romesh C. Committee Member Johnson, Eric R. Committee Member Plaut, Raymond H. Committee Member Thangjitham, Surot Committee Member Keywords
- functionally graded material
- adhesively bonded joints
- dynamic fracture
- interface damage mechanics
- extended finite element method
Date of Defense 2005-09-05 Availability unrestricted AbstractUsing experimental data obtained from standard fracture test configurations, theoretical and numerical tools are developed to mathematically describe non-self-similar progression of cracks without specifying an initial crack. A cohesive-decohesive zone model, similar to the cohesive zone model known in the fracture mechanics literature as the Dugdale-Barenblatt model, is adopted to represent the degradation of the material ahead of the crack tip. This model unifies strength-based crack initiation and fracture-mechanics-based crack progression.
The cohesive-decohesive zone model is implemented with an interfacial surface material that consists of an upper and a lower surface that are connected by a continuous distribution of normal and tangential nonlinear elastic springs that act to resist either Mode I opening, Mode II sliding, Mode III sliding, or a mixed mode. The initiation of fracture is determined by the interfacial strength and the progression of the crack is determined by the critical energy release rate. The adhesive is idealized with an interfacial surface material to predict interfacial fracture. The interfacial surface material is positioned within the bulk material to predict discrete cohesive cracks. The interfacial surface material is implemented through an interface element, which is incorporated in ABAQUS using the user defined element (UEL) option.
A procedure is established to formulate a rate dependent model based on experiments carried out on compact tension test specimens. The rate dependent model is incorporated into the interface element approach to capture the unstable crack growth observed in experiments under quasi-static loading conditions. The compact tension test gives the variation of the fracture toughness with the rate of loading, this information is processed and a relationship between the fracture toughness and the rate of the opening displacement is established.
The cohesive-decohesive zone model is implemented through a material model to be used in an explicit code (LS-DYNA). Dynamic simulations of the standard test configurations for Mode I (Double Cantilever Beam) and Mode II (End Load Split) are carried out using the explicit code. Verification of these coupon tests leads to the crash analysis of realistic structures like the square composite tube. Analyses of bonded and unbonded square tubes are presented. These tubes shows a very uncharacteristic failure mode: the composite material disintegrates on impact, and this has been captured in the analysis.
Disadvantages of the interface element approach are well documented in the literature. An alternative method, known as the Extended Finite Element Method (XFEM), is implemented here through an eight-noded quadrilateral plane strain element. The method, based on the partition-of-unity, is used to study simple test configuration like the three-point bend problem and a double cantilever beam. Functionally graded materials are also simulated and the results are compared to the experimental results available in the literature.
Filename Size Approximate Download Time (Hours:Minutes:Seconds)
28.8 Modem 56K Modem ISDN (64 Kb) ISDN (128 Kb) Higher-speed Access thesis_project.pdf 10.02 Mb 00:46:23 00:23:51 00:20:52 00:10:26 00:00:53
If you have questions or technical problems, please Contact DLA.