Title page for ETD etd-12072004-095231


Type of Document Master's Thesis
Author Keen, Ernest Brock
Author's Email Address erkeen@vt.edu
URN etd-12072004-095231
Title A Conceptual Design Methodology for Predicting the Aerodynamics of Upper Surface Blowing on Airfoils and Wings
Degree Master of Science
Department Aerospace and Ocean Engineering
Advisory Committee
Advisor Name Title
Mason, William H. Committee Chair
Gelhausen, Paul Committee Member
Schetz, Joseph A. Committee Member
Keywords
  • aerodynamics
  • conceptual design
  • USB
  • upper surface blowing
Date of Defense 2004-11-29
Availability unrestricted
Abstract
One of the most promising powered-lift concepts is Upper Surface Blowing (USB), where the engines are placed above the wing and the engine exhaust jet becomes attached to the upper surface. The jet thrust can then be vectored by use of the trailing edge curvature since the jet flow tends to remain attached by the "Coanda Effect". Wind tunnel and flight-testing have shown USB aircraft to be capable of producing maximum lift coefficients near 10. They have the additional benefit of shielding the engine noise above the wing and away from the ground.

Given the potential gains from USB aircraft, one would expect that conceptual design methods exist for their development. This is not the case however. While relatively complex solutions are available, there is currently no adequate low-fidelity methodology for the conceptual and preliminary design of USB or USB/distributed propulsion aircraft. The focus of the current work is to provide such a methodology for conceptual design of USB aircraft. Based on limited experimental data, the new methodology is shown to compare well with wind tunnel data.

In this thesis we have described the new approach, correlated it with available 2-D data, and presented comparisons of our predictions with published USB data and an existing non-linear vortex lattice method. The current approach has been shown to produce good results over a broad range of propulsion system parameters, wing geometries, and flap deflections. In addition, the semi-analytical nature of the methodology will lend itself well to aircraft design programs/optimizers such as ACSYNT. These factors make the current method a useful tool for the design of USB and USB/distributed propulsion aircraft.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  EBKThesis_121004.pdf 14.05 Mb 01:05:02 00:33:27 00:29:16 00:14:38 00:01:14

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.