Title page for ETD etd-12102007-173009


Type of Document Master's Thesis
Author White, Brady Alexander
Author's Email Address brwhite1@vt.edu
URN etd-12102007-173009
Title Dynamic Modeling of a Supersonic Tailless Aircraft with All-moving Wingtip Control Effectors
Degree Master of Science
Department Aerospace and Ocean Engineering
Advisory Committee
Advisor Name Title
Mason, William H. Committee Chair
Hall, Christopher D. Committee Member
Inman, Daniel J. Committee Member
Woolsey, Craig A. Committee Member
Keywords
  • six degree-of-freedom dynamic model
  • tailless configuration
  • all-moving tips
Date of Defense 2007-12-07
Availability unrestricted
Abstract
A six degree-of-freedom model for a tailless supersonic aircraft (TSA) concept was developed using MATLAB and Simulink. Aerodynamic data was provided through the computational fluid dynamics analysis of Techsburg, Inc. A three degree-of-freedom model of the configuration’s longitudinal dynamics was completed first. Elevator control power was derived from the dynamic response requirements for pitch chosen by Techsburg. The propulsion model utilized General Electric F-414-400-like turbofan engines because an engine deck was readily available. Work on the six degree-of-freedom dynamic model began with determining the necessary rolling and yawing moment coefficients necessary to meet the rest of the chosen dynamic response requirements. These coefficients were then used to find the corresponding all-moving tip deflections. The CFD data showed that even at small all-moving tip deflections the rolling moment coefficient produced was much greater than the amount of yawing moment coefficient produced. This result showed that an additional roll effector was needed to counteract excess rolling moment at any given all-moving tip deflection and trim the aircraft. An angle of attack and pitch rate feedback controller was used to improve the longitudinal dynamics of the aircraft. Because this configuration lacked a vertical tail, a lateral-directional stability augmentation system was vital to its success. The lateral-directional dynamics were improved to Level 1 flying qualities through use of a modified roll/yaw damper. The modified controller fed yaw rate back to both the all-moving tips and roll effector. The six degree-of-freedom model was augmented with actuator dynamics for the elevator, roll effector, and all-moving tips. The actuators were modeled as first order lags. The all-moving tip actuator time constant was varied to determine the effect of actuator bandwidth on the lateral-directional flying qualities. After the actuator dynamics were successfully implemented, the six degree-of-freedom model was trimmed for both standard cruise and engine-out situations. The eccentuator concept from the DARPA Smart Wing program was selected as a possible conceptual design for the all-moving tip actuation system. The success of the TSA six degree-of-freedom dynamic model proved that morphing all-moving tips were capable of serving as effective control surfaces for a supersonic tailless aircraft.
Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Brady_White-Copyright_Permissions-Sage_Publications_(2).jpg 24.55 Kb 00:00:06 00:00:03 00:00:03 00:00:01 < 00:00:01
  Brady_White-Copyright_Permissions-Techsburg_Inc..jpg 113.44 Kb 00:00:31 00:00:16 00:00:14 00:00:07 < 00:00:01
  Brady_White-MS_Thesis.pdf 410.98 Kb 00:01:54 00:00:58 00:00:51 00:00:25 00:00:02
  Brady_White_-Copyright_Permissions-Sage_Publications_(1).jpg 162.81 Kb 00:00:45 00:00:23 00:00:20 00:00:10 < 00:00:01

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.