Title page for ETD etd-32498-135818


Type of Document Master's Thesis
Author Tong, Chao
Author's Email Address ctong@vt.edu
URN etd-32498-135818
Title The Effectiveness of Splicing Notched Pallet Stringer Segments With Metal Connector Plates
Degree Master of Science
Department Wood Science and Forest Products
Advisory Committee
Advisor Name Title
White, Marshall S. Committee Chair
Araman, Philip A. Committee Member
Dolan, James Daniel Committee Member
Loferski, Joseph R. Committee Member
Keywords
  • stringer
  • spliced stringer
  • metal connector plate
  • truss plate
  • splice
  • pallet
  • ultimate strength
  • stiffness
Date of Defense 1997-08-01
Availability unrestricted
Abstract
Notched stringer segments spliced with metal connector plates (MCPs) and pallets with spliced stringer(s) were tested in static bending in order to determine the relative effectiveness of different stringer splicing methods and under what conditions the process is or is not effective. The species tested were oak, southern yellow pine, yellow-poplar, and two combined species - oak and yellow-poplar, and oak and southern yellow pine. The metal connector plates used were 3 x 4-inch, 3 x 6-inch truss plates, and a 3 x 4-inch plug plate.

The splice methods tested were a vertical splice (VS), a 45° angle splice (AS), and a vertical splice with -inch gap between segments (VSG). The results of bending tests of these specimens were compared to non-spliced whole stringers and pallets containing whole stringers. Multiple comparison, statistical methods were used to analyze all test data. An analysis of the failure locations and types of specimens was also used to analyze test results.

Vertical spliced stringers with 3 x 4 and 3 x 6 inch truss plates were the best designs of those tested. Spliced stringers were an average of 112% and 74% bending strength and stiffness of new non-spliced stringer. These plates were an average of 26% stronger and 13% stiffer than the 3 x 4 inch plug plate splice stringer. There was no difference between the performance stringers spliced with 3 x 6 and 3 x 4 inch truss plate. An angle splice design and the addition of 1.25 x 6 inch truss plate on the tension side of spliced stringer did not appear to improve the strength and stiffness. A gap between segments significantly reduces splice strength and stiffness by an average of 35% and 16% respectively. When mixing stringer segment species, the performance is determined by the weaker segment.

The average strength and stiffness of pallets containing spliced stringers were similar to that of pallets with whole stringers, however the variation in performance was greater when notched stringer pallets contain splices.

Files
  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  thesis-list.pdf 20.31 Kb 00:00:05 00:00:02 00:00:02 00:00:01 < 00:00:01
  thesis.pdf 1.27 Mb 00:05:54 00:03:02 00:02:39 00:01:19 00:00:06
  THESIS_CO.PDF 49.79 Kb 00:00:13 00:00:07 00:00:06 00:00:03 < 00:00:01

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.